Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

CBWFQ and ibound service-policy

Hi,

we have a frame-relay connection with LLQ applied to it for

outbound traffic and we want to apply the same policy for

inbound traffic as well but when we try this we get the

error:

CBWFQ : Can be enabled as an output feature only

any ideas?

the existing configuration of the interface is:

!

interface Serial0/0

no ip address

encapsulation frame-relay

no ip route-cache

no ip mroute-cache

load-interval 30

frame-relay traffic-shaping

frame-relay lmi-type q933a

end

interface Serial0/0.1 point-to-point

bandwidth 128

backup delay 0 180

backup interface Dialer0

ip address 10.0.8.129 255.255.255.252

no ip route-cache

ip ospf network point-to-point

no ip mroute-cache

no cdp enable

frame-relay interface-dlci 20

class CIR_128KTF

frame-relay ip rtp header-compression

map-class frame-relay CIR_128KTF

no frame-relay adaptive-shaping

frame-relay cir 128000

frame-relay bc 1000

frame-relay be 0

frame-relay mincir 64000

service-policy output policy_128K

frame-relay fragment 160

policy-map policy_128K

class voice

priority 60

class sna

bandwidth 30

class class-default

fair-queue

thanks

yiorgos

1 REPLY
New Member

Re: CBWFQ and ibound service-policy

You really can't tweak queuing on inbound traffic. You would need to configure the other side of the link with outbound queuing.

139
Views
3
Helpful
1
Replies
CreatePlease to create content