Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CBWFQ and offered rate

Hi,

Couple of questions about CBWFQ ;

1) Is it normal for offered rate to go higher then the bandwidth of my interface ?

2) On a 7513 router with an ATM OC3, if I configure my Classes as a percentage, the calculated number of Kbps allocated to each class seems higher then what it should. It this because the router accounts for the ATM cell overhead ?

Thanks

1 REPLY
Silver

Re: CBWFQ and offered rate

On ATM interfaces the Layer-3 queuing mechanism does not take into accout the cell overhead i.e. a 64 byte packet is couted as 64 by CBWFQ but as 106 by the ATM interace - 2 x 53 Byte Cells.

There is a good doc on CCO covering ATM overhead and CBWFQ:

What Bytes Are Counted by IP to ATM CoS Queueing -

http://www.cisco.com/en/US/partner/tech/tk39/tk824/technologies_tech_note09186a00800942f5.shtml

94
Views
0
Helpful
1
Replies
CreatePlease login to create content