Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

ns
New Member

CBWFQ : Can be enabled as an output feature only

I get this message on a 3620 router with a 2FE-2W module when I try to apply an input service-policy to one of the FE interfaces. The router is using IOS 12.1(5)T12. The router already has an output service-policy configured. Is this a limitation of the 3620 router or is it a limitation of the software?

I'm using some 3620s in our lab. I need to implement this on a 7507 router with a PA-FE interface w/ VIP2-50. Can I police/shape the traffic on the 7500 using input and output service-policies?

Thanks,

Niels

2 REPLIES

Re: CBWFQ : Can be enabled as an output feature only

Policing can be be configured, inbound as well as outbound but Class based Shaping can be applied only as a outbound feature.

May be you are trying to do CBshaping and hence its not taking the service policy command in the inbound direction.

ns
New Member

Re: CBWFQ : Can be enabled as an output feature only

I first used a police 256000 32000 32000 conform-action.... command and got this message

Then I tried a shape average and it gave me the same message.

218
Views
0
Helpful
2
Replies