Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CCNA Voice lab setup..

I am CCNA certified and starting to work on my
CCNA Voice cert.

What I already have is a 2650XM Router with
CME 4.1, a bunch of phone profiles, GUI for
CME, 1 ethernet port and 1 serial port.

I already have a 7960 IP Phone.

And I have CUCM on a VM partition.

So, I was looking at other CCNA Voice labs
online and this is what I have just ordered.

An additional 2600 router with 2 ethernet and
1 serial port (and DCT DTE cable)

A Catalyst 2900 switch (24-port)

A 7940-G IP phone.

A VIC 2FXS Card (for 2650 router)

I am looking at some labs online. Some say I need
to switches but I believe I can VLAN out my 2900
into 2 virtual switches and that should work.

Anyone else have any other suggestions?

I am also looking for resources for
CCNA Voice labs. 

Any help woule be appreciated.

CreatePlease login to create content