I've to propose a cisco equipment list to setup a complete lab for "CCNP R&S" course, this lab setup should be able to simulate the entire course contents/theories of the three modules including route, swithc and Tshoot).
So what is the recommended lab setup to met the above requirment? Further we are looking forward to purchase new equipment, rather than considering the re-purbished equipments. Please advise.
To cover the switch portion, you would want two 3560 models (3560, 3560G, 3560E, 3560X, depending on how much money you have to burn) and two 2960 models (again, G, PoE, etc) depending on what you're after.
For routers, I haven't finished building my lab yet, but I'd want 1841's or 19xx's. Something that can run 15.x code. I think to really run anything, you'd want at least 4 routers, plus serial WIC-1T cards, serial crossover (DB-60) cables, and at least a 4 port serial module for one router. I'd probably want at least one big router, like a 3845 or 39xx.
I'd probably want 4 18xx/19xx remote site routers, and 1 38xx/39xx hq site router. You can use GNS3 to simulate the routers though really, so most of my focus has been on switches.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...