Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

CDP Error? trying...

Dear Sir!

Cisco write, that CDP works over FrameRelay (as SNAP-capable link).

But however hard I may try, but I can't see Frame Relay switch by CDP in my lab!

What CDP configuration must I use on my FrameRelay switch?

Best regards,

Nick

2 REPLIES
Gold

Re: CDP Error? trying...

It may be disabled on serial interfaces. gointo config mode for the Interface

and try a CDP enable....

hth

Bronze

Re: CDP Error? trying...

I assume that the FR switch is a cisco IOS device? If not, this won't work. If it is, make sure that you have recent code on the devices, as there could be bugs (although I don't see any specific bugs right now could apply). In terms of configuration, there isn't a lot to it besides "CDP run" (global) and "cdp enable (per interface).

91
Views
0
Helpful
2
Replies
CreatePlease to create content