10-03-2006 06:31 AM - edited 03-03-2019 05:21 AM
Hi
How do you change the config registers on a Cisco 3750G so that I can change the boot parameters to boot from a new image ?
Thanks
Mike
10-03-2006 06:50 AM
hi
Use this boot commands to boot from a new image
!
set boot command
set boot config-register 0x2
set boot system flash bootflash:cat4000.6-3-10.bin
!
HTH
Thanks
Raj
10-03-2006 07:04 AM
Hello Raj
These commands do not work on the 3750G I have, running IOS c3750-ipbase-mz.122-25.SEB4 ?
Mike
10-04-2006 01:01 AM
The only set command on the switch is Set Memory Debug or set express. It does not provide me with any other options to configure boot parameters.
help !!!
10-04-2006 05:46 AM
Hi,
there is the "boot system" global configuration command by which you can specify the IOS image to load. However when upgrading the switch via "archive download-sw" you normally do not need to use this command as the boot variable is set up automatically (you can check via "show boot" command.
Best regards,
Antonin
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: