Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Changing Native VLAN for 3500XL

I want to use VLAN 300 for the native (management) VLAN on a 3500XL. How do I do that on the 3500? I am using .1Q on GigabitEthernet0/1 that is connecting to a 6509. I have setup the port for trunking on the 6509 and specified the vlan as 300 for management.

4 REPLIES
Silver

Re: Changing Native VLAN for 3500XL

This should do the trick on your trunk interface.

switchport trunk native vlan 300

interface GigabitEthernet0/1

no ip address

shutdown

switchport

switchport trunk encapsulation dot1q

switchport trunk native vlan 300

switchport mode trunk

end

Hope this helps,

Don

New Member

Re: Changing Native VLAN for 3500XL

Don,

Do I then create an interface for VLAN300 on the switch or do I used VLAN 1 and then assign the IP address?

Cisco Employee

Re: Changing Native VLAN for 3500XL

Native Vlan is nothing to do with the management vlan. If you want Vlan 300 has the management Vlan, then please create int vlan 300 , and please make sure you shutdown the vlan 1 before doing no shut on the vlan 300

Native vlan is the vlan which is not tagged when trunking is on the port.

New Member

Re: Changing Native VLAN for 3500XL

Thank you.

95
Views
0
Helpful
4
Replies