Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Changing Native VLAN

Can you change the native vlan on a 5500?

I have a 5500 connected to a 8540. The 8540 subinterface for VLAN 1 has "native" defined.

If I want to configure a different subinterface/vlan for management, do I have to remove the "native" statement from the other subinterface? Once I change this will the new native vlan show up in the 5500?

2 REPLIES
Anonymous
N/A

Re: Changing Native VLAN

yes you can.

You may change the native VLAN on 5500, if needed, by using the following command:

cat5509> (enable) set vlan

here is the new Native Vlan and is the trunk port.

Be sure to use it same across your network if you plan to use vlan tagging.

Cisco Employee

Re: Changing Native VLAN

If you want to change the native VLAN on that connection, simply move the native keyword to a different sub-int on the 8540 and change it on the cat5k by using the command: set vlan [vlan#] [mod/port]

97
Views
0
Helpful
2
Replies