What are the consequences of changing the OSPF default metric cost. We have a situation with a FDDI and a FASTETHERNET interfaces on the same router with the same default cost of 1. If we wanted to force the devices connected to use the FDDI first and the FASTETHERNET only for fault tolerance, would it be ok to increase the FASTETHERNET interface cost to 2?
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...