ok syslog in switches, default logg severity is 4, people want to see config changes which is a sys facility with a severity of 6, so if you change logg serve severity to 6, it works and loggs config changes, but also loggs all pagp level 5 events which is ports deinsserting and reinserting, so i figure if i set logg serve severity to 4 and set logg level sys 4 default this should change sys messages to a severity of 4 and thereby the should be logged, this doesnt work, any ideas?
You can't change a message from one severity level to another. A sev 6 message stays a sev 6 message. You need to change the logging level for the sys facility to 6 so you will get all messages thru sev 6.
What you can do is set the default logging level to 4 and set the log level for sys to 6.
set logging level all 4 default (set all logging to 4)
set logging level sys 6 default (change the setting to 6 for sys... this will show all sys messages for log levels 0-6 )
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...