Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Changing the boot parameters on a 3750G

I have a couple of Cisco 3750G switches currently running c3750-ipbase-mz.122-25.SEB4. I have already uploaded the new image and entered boot flash:c3750-advipservicesk9-mz.1

22-25.SEE2.bin

The boot file now contains..

BOOT path-list : flash:c3750-advipservices9-mz.122-25.SEE2.bin.

But when I reboot the switch it still loads the original image and not the new one...

Can anyone help ?

3 REPLIES
Cisco Employee

Re: Changing the boot parameters on a 3750G

Hi Friend,

I see that the new image which you have upgraded is "c3750-ipbase-mz.122-25.SEB4" but the boot path is set to

"c3750-advipservices9-mz.122-25.SEE2.bin" which I thin kis your old image.

So can you try deleting or clearing old boot path and set a new boot path for new image and see if that works.

HTH

Ankur

Community Member

Re: Changing the boot parameters on a 3750G

It appears that the image name in the BOOT path-list is spelled incorrectly...it is missing the k (.....k9-mz.122.....). I would try doing a "boot system flash:c3750-advipservicesk9-mz.122-25.SEE2.bin"

Tim

Re: Changing the boot parameters on a 3750G

Isuue the following command in the global configuration mode

(config)#boot system flash:c3750-advipservicesk9-mz.122-25.SEE2.bin

Reload the router.

After the reload, check the boot file status with the show boot command. It should have loaded the new IOS and would reflect in your boot file.

HTH

Narayan

5988
Views
0
Helpful
3
Replies
CreatePlease to create content