Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Changing the defaults of flowcontrol

The 6:1 or 8:1 relationship means that 6 or 8 Gigabit ports share a 1 Gb connection to the backplane of a 4006 or 450x switch (in my case it applies to a 48 port line card). But, can I change the defaults of flowcontrol..?...I mean, Is it possible to change flowcontrol send on and flowcontrol receive desired (default for blocking ports) and convert in a 1:1 mapping, ie to flowcontrol send off and flowcontrol received desired, and it works..?...through this way could I obtain a 1 Gb connection to the backplane..?

1 REPLY
Silver

Re: Changing the defaults of flowcontrol

check the following link for configuring flow control on gigabit ethernet ports on Catalyst 4000 series switches :

http://www.cisco.com/en/US/products/hw/switches/ps663/products_configuration_guide_chapter09186a00800d81a5.html#31236

141
Views
0
Helpful
1
Replies