Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Channelised E1 leased Line

We have a typical type of scenario where customer has 30 differrent remote branches to be terminated to the central router.Omantel ( Service provider ) has suggested a channelised E1 leased line to the customer which will accomodate all the 30 branches in one with a 64k time slot reserved for each branch.This distribution of time slots will be done from the exchange itself.

We will have to suggest a cisco solution on this basis.At remote branches we can go for any small router say 1721 with WIC-1T.What kind of module is required at the central router to terminate this channelised E1 leased line and how it will work.

I also need help in configuring the same channelised E1 Port , if you can send me a sample configuration file.How the differrent 30 remote branches will be configured at this single channelised E1 port. The protocol used will be IP only.

Sanjay Sangwan

NTS, Muscat ,Oman

  • Other Network Infrastructure Subjects
2 REPLIES

Re: Channelised E1 leased Line

hi

u need to install 1 Channelized E1/PRI port in u r router. simple config of the channelised E1 card ..

controller E1 2/0

framing NO-CRC4

channel-group 0 timeslots 1

channel-group 1 timeslots 2

channel-group 2 timeslots 3

channel-group 3 timeslots 4

channel-group 4 timeslots 5

channel-group 5 timeslots 6

channel-group 6 timeslots 7

channel-group 7 timeslots 8

channel-group 8 timeslots 9

channel-group 9 timeslots 10

channel-group 10 timeslots 11

channel-group 11 timeslots 12

channel-group 12 timeslots 13

channel-group 13 timeslots 14

channel-group 14 timeslots 15

channel-group 15 timeslots 16

channel-group 16 timeslots 17

channel-group 17 timeslots 18

channel-group 18 timeslots 19

channel-group 19 timeslots 20

channel-group 20 timeslots 21

channel-group 21 timeslots 22

channel-group 22 timeslots 23

channel-group 23 timeslots 24

channel-group 24 timeslots 25

channel-group 25 timeslots 26

channel-group 26 timeslots 27

channel-group 27 timeslots 28

channel-group 28 timeslots 29

channel-group 29 timeslots 30

channel-group 30 timeslots 31

then u need to configure the corresponding port where the card is goinge to be installed.

consider if u r installing @ the 1st slot,u need to configure like the following..

interface Serial1/0:0

ip address x.x.x.x y.y.y.y

.

.

.

interface Serial1/0:30

ip address a.a.a.a b.b.b.b

like this u need to configure all the 30 slots which r getting connected to the remote locations.other things like configuring encap,ratelimit,traffi-shape etc., is similar to configuring a simple serial port.

regds

prem

New Member

Re: Channelised E1 leased Line

Thanks a lot prem.You have really helped me a lot

sanjay

1196
Views
0
Helpful
2
Replies
This widget could not be displayed.