We have 3660 routers connected to our existing WAN, we are using VOIP interface to our md110 pbx. In our cisco 3660 routers we have 3 Channelized E1 controllers installed in different modules in the same routers (i.e E1 2/0, E1 3/0, and E1 4/0) all in all we have 90 channels available.How can I test let say the first E1 controller is down or fail, supposed to be the second E1 controller is taking over the calls because the other 2 E1 controller is working. I tried to shutdown the first E1 controller to check if the other E1 controllers is taking over. When I shut down the 1st E1 the second E1 controller did not take the calls. Is there any commands to add in my configuration to tell to my router that the first controller is down, used the second controller or the available controller. Please I need your advice and immediate solution for this problem.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...