CISCO 1005 Internet Routing

[jtrogdon]

Cisco 1005 ----- Hub --- PC

|

|WAN T1

|

Cisco 1700 ---- Hub - Cable Modem Router

The Cisco 1005 has the Ethernet setup as 192.168.5.x and the Serial setup as 192.168.4.x. The Cisco 1700 has its Ethernet setup as 192.168.3.x.

From the PC, I can ping my cable modem router which is on 192.168.3.10 (across the T1). However, if I try and do a tracert on an address that is not in the 192.168.x.x range, the trace stops at 192.168.5.1.

I want the PC to be able to browse the web using the cable modem on 192.168.3.10. How do I setup the Cisco 1005 to allow this to happen?

[preddyi]

Pls check if default gateway is configured in 1005 router.

If not configure default route in 1005 pointing the gateway as serial interface of 1005 or wan ip of 1700 router.

ip route 0.0.0.0 0.0.0.0 serial0

Also make sure that PC's defualt gateway is LAN IP of 1005