cisco 1601 time based access-list

[karoly.mathe]

Hi All,

I have a cisco 1601 router with 12.0(21a)image and I want to make some time based access list. But when I tried to issue the time-range command router respond with unknown command. What's the problem? I read that this command is available on all platform from release 12.0.

Thank's in advance

Karoly

[rsissons]

You need to use the 12.0T train images.

[karoly.mathe]

Thank you for your response. I will try to upgrade to image 12.1-13 or 12.2-7b. Either of the above are good?

[thisisshanky]

Before upgrading to a new image, a few things have to be considered.

How much flash memory you have. How much DRAM. What hardware modules you have. etc. Also you need access to CCO software center to download the right software/feature set. You can use Software Advisor on Ciscos website to find out the right image for your hardware/software requirement.

http://www.cisco.com/cgi-bin/Support/CompNav/Index.pl?Introduction=True