Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Cisco 1601

I have 1601, i cannot access the router through console port , session dos not

start.

any solution for this

manish young

4 REPLIES

Re: Cisco 1601

Did u check the cable, and the connectors used to access the console ??

Also please check the Hyperterminal (or the software u r using) settings...?? It should 9600 8 1 No flow control..

Hope that helps..

New Member

Re: Cisco 1601

hi agian,

i have tried diffrent connectors & correct hyper terminal setting, but it dosent work.

manish young

Bronze

Re: Cisco 1601

Assuming the router is not active/running,

if you have used/done the following:

1. Correct COM port and Hyperterm settings:

- 9600 baud

- 8 databits

- no parity

- 1 stop bit

- no flow control

2. Correct and working console cable

(A console cable that was previously used in other routers or switch)

and if nothing is displayed in your teminal window after powering ON the

router, then it could be a defective console port or probably a defective router.

New Member

Re: Cisco 1601

thanks,

i think my router's console port is gone ,bec i can access through telnet

with regards

manish young

295
Views
1
Helpful
4
Replies
CreatePlease to create content