Cisco 1700 connected to Satellite transceiver for 'net access
We are trialling a internet access Satellite for BT. We have attached our own 1700 router to the Gilat Sat box via a cross-over cable and can browse the net over this, albeit very slowly.
Tech Support in BT told us to route via the ip port 9877 on the Sat box - which we did via a laptop directly connected (the Sat Box has a dhcp server) - i.e. set the Int. Explorer proxy settings to "ip adddress of sat box":9877 - this resulted in connection speeds about 20 times quicker (the 9877 port uses different packet sizes and various compression algorithms).
The big question is then :- how do we get the 1700 router to route via this port ? - and so enable this quicker access to the LAN and not just a single PC.
Re: Cisco 1700 connected to Satellite transceiver for 'net acces
If I understand correctly, it sounds like you are saying that the 1700 has to translate the source (or destination?) port to 9877 for all packets that pass through the 1700. This sounds strange, since if it is a requirement of the Sat box then it should be doing the translation. But the only way that I can see to do this is with PAT or NAT, and both are described pretty well in the online documentation.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.