i have a client with two Cisco ISDN routers (1700) Configred With Both IP and IPX. There is two Netweare servers on Each end and they Use Ethernet_II protocol. IP works all the TIME but IPX disconnects so often that causes Servcers to disappear, The routers are Routing IPX . Any Ideas where to look first.
It pains me to say this - but it is well beyond the time to get rid of IPX. It was a good protocol in its day, but it just is not the best solution anymore - especially if you are already running IP. Best to use this as an excuse to stomp out IPX and get down to only one protocol on the wire.
Novell has recommended IP for years and has great support for all services.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...