I have a 1700 series router that gives me the error message "Insufficient memory to boot the image" when it is rebooted. I searched all over the WEB for a solution. Does anyone have an answer on how to fix this problem. Thanks in Advance!
Vince is quite right. I use a lot of 1700s and units purchased as recently as a few months ago with the "standard" 8/24 Meg of memory will not support 12.2 code. I think you need at least 8/32 for just run-of-the-mill 12.2 code and even more for certain feature packs.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...