Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Cisco 1750 and T1 Data/Voice Configuration

I'm fairly new to this and have a question.

I have a Cisco 1750 with a T1 DSU/CSU interface card connected to a point-to-point T1 circuit configured for data only. The physical connection is one cat5 cable connected to the T1 provider and the other end to the Cisco 1750 T1 DSU/CSU interface card.

Now I need to split the T1 circuit and alocate some channels for data and some for voice.

Question

Since only one cable is comming out of the T1 provider, what would I need to physically split the cable comming from the provider so I can connect the Cisco 1750 and my phone equipment? Does Cisco offer such h/w do this?

Since I have DSU/CSU intergrated in the T1interface card on the 1750, how do I physically connect my phone equipment to the cisco router?

Hope this make sense.

1 REPLY
Bronze

Re: Cisco 1750 and T1 Data/Voice Configuration

You would need to use a VWIC-2MFT-T1-DI card for this on the 1750 - need IOS 12.2.4YB or 12.2.8YJ with a voice feature set image:

http://www.cisco.com/univercd/cc/td/doc/product/access/acs_mod/1700/1751/t1e11700.htm#xtocid19

214
Views
0
Helpful
1
Replies
CreatePlease to create content