Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

cisco 2500

it just happened after I did recovery the password when 2500 boot up it comes up with all

CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC

I can't ping it or telnet or even use Heyper Terminal Any idea? Thanks

2 REPLIES
New Member

Re: cisco 2500

I got it up

I changed to terminal

1200 baud rate

config 0x2102 it was 0x1242

copy running-config startup-config

reload

now I am able to use normal Heyper Terminal

9600 baud rate

No parity

8 data bits

1 stop bit

No flow control

Highlighted
New Member

Re: cisco 2500

I guess I lost all the configurations. By any chance can I recovery the old configuration, is not on startup-config or running-config

Thanks

101
Views
0
Helpful
2
Replies
CreatePlease to create content