Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco 2600 Dial up

i have a router 2600 with a integrated modem 16 ports.

when i call the number of telephone related to the modem . there is no request by the modem.

can y ou help me please.

thank you

3 REPLIES

Re: Cisco 2600 Dial up

Your ISDN interface config should look like this:

interface Serial1/0:15

no ip address

no ip directed-broadcast

encapsulation ppp

no logging event link-status

dialer rotary-group 1

isdn switch-type primary-net5

isdn incoming-voice modem

The crucial command is in the last line.

This is a system with a PRI. Dunno what you are using. With BRI interfaces, put this under the corresponding BRI.

Cisco Employee

Re: Cisco 2600 Dial up

Pl. post the running config here.

Here is the link which has a sample config for 16 analog modems receiving the calls.

http://www.cisco.com/warp/public/471/nm-xam_dialin.html

Bronze

Re: Cisco 2600 Dial up

If you just wanted to test if the modem will answer your call, add these commands under "line 1 16"

line 1 16

modem inout

transport input all

stopbits 1

flowcontrol hardware

modem autoconfigure discovery

You should be able to hear a modem tone once your call has been answered.

Then if you want to proceed, just post it...

Hope this helps.

100
Views
0
Helpful
3
Replies