Cisco 2600 is not accepting commands in rommon mode
We had an image in router 2600 which we thought of upgrading. As there is memory constraint, we deleted the image. But still the router was showing image deleted and the memory is not freed. We tryed squeeze command but it didn't work. Finally we rebooted the router and landed in rommon mode. Here in rommon mode, it is accepting only some of the commands and that too after typing the same for around 15 to 20 times. We are not able to copy the new image from tftp as the command is not accepted. Hard rebooting the router also did not work. Plz someone help.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...