cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
368
Views
0
Helpful
3
Replies

Cisco 2600 Router Problem

gvijayendran
Level 1
Level 1

After configuring the router, the config files are saved by using "copy running-config startup-config" command. when the router is rebooted, instead of giving the hostname> prompt, it goes to initial configuration mode and asks for enter initial config mode y/n ? when no is pressed, it goes to router> prompt and whatever configurations already done are lost.

How to resolve this issue ? Can someone help me?

3 Replies 3

rgodden
Level 3
Level 3

what are the config registers set to ?

Show ver will show the current config register in the last line. Try it and see what is is set to. Then go into config mode and enter the global command "config-register 0x2102"; exit and save conf ig then reboot. Your old config may show up after the boot or you may have to put it in again and save it..

Thank You very much sir, i got the problem solved.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: