Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cisco 2600 Router Problem

After configuring the router, the config files are saved by using "copy running-config startup-config" command. when the router is rebooted, instead of giving the hostname> prompt, it goes to initial configuration mode and asks for enter initial config mode y/n ? when no is pressed, it goes to router> prompt and whatever configurations already done are lost.

How to resolve this issue ? Can someone help me?

3 REPLIES
New Member

Re: Cisco 2600 Router Problem

what are the config registers set to ?

Bronze

Re: Cisco 2600 Router Problem

Show ver will show the current config register in the last line. Try it and see what is is set to. Then go into config mode and enter the global command "config-register 0x2102"; exit and save conf ig then reboot. Your old config may show up after the boot or you may have to put it in again and save it..

New Member

Re: Cisco 2600 Router Problem

Thank You very much sir, i got the problem solved.

163
Views
0
Helpful
3
Replies