Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Cisco 2600 with NM-1A-T3 DS3 ATM Module

I had recently just purchased a Cisco 2600 router, a DS3 ATM module, a 1 port Serial adapter separately.

Searching through the Hardware/Software Matrix, shows that IOS 12.2(2)T is one of the appropriate software to be used for this combination.

Cisco 2600

NM-1A-T3

WIC-T1

However, after loading in the IOS, the router display an error message "%PA-2-UNDEFPA: Undefined Port Adapter type 426 in bay 1"

Please advise what is the best solution to this issue.

1 REPLY
Anonymous
N/A

Re: Cisco 2600 with NM-1A-T3 DS3 ATM Module

Requires an IOS "Plus" or Service Provider ("-p-") feature set

273
Views
0
Helpful
1
Replies
CreatePlease to create content