We have some cisco 2611 routers configured in async mode. They are not able to dial out. We can dial in to thosse routers. Configuration should not be the problem as other 2611 are working with same config. modems are also dialing out on other routers.
Will need to see the following debug outputs when a call OUT is attempted.
debug ppp nego
Also we need to ensure the following in the config:
1)Appropriate route (static /dynamic) exsists.
2)We have interesting traffic defined, as required for ddr.
3)The dial out interface is in UP & UP (spoofing) mode...basically that there is no backup command (under another interface)that puts this interface in standby mode....shouldn't be in this case since we can dial in.
4)Under the lines atleast have: modem inout/ transport in all / autoslect ppp (if interactive used under asyn interface)
Does reverse telnetting into the modem & calling out using ATDT work?
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...