I currently have a 2620 router with an ADSL-WIC card installed. I'm trying to configure this setup for my users for internet access. I have 6 static IP addresses. I have started configuring the router and get as far as the card is recognized and comes up as recognizing the ADSL line, but I don't get much further. Does anyone have a working configuration that they would like to share that would cover this scenario? My next step is to open a VPN tunnel back to my main facility and to my VPN3000 box. I think I have that part covered if only I can get the remote router working. Any help would be greatly appreciated.
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...