cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
196
Views
0
Helpful
1
Replies

Cisco 2621 does not recognize 1-port ADSL WIC

boyd-c
Level 1
Level 1

Running IOS 12.2(6r). Installed WIC mentioned above in slot W0. Slot W1 is empty.

I went through initial configuration and set up FastEthernet0/0 and 0/1.

It doesn't seem to recognize the WIC at all and there are no lights.

I tried bringing it up using INTERFACE Serial0/0, "" Serial0/1.

Still nothing.

I'm not sure if the ADSL line is active but would the card still not be recognized?

Obviously I'm a bit new to routers.

TIA

1 Reply 1

tepatel
Cisco Employee
Cisco Employee

For 2600, WIC-1ADSL first supported in Cisco IOS Release 12.1(5)YB - now supported in Cisco IOS Releases 12.2(4)T, 12.2(2)XK, 12.2(4)XL onwards..and Requires a Cisco IOS "Plus" image..

Pl. locate "ios and paltform support" section on following url for more information

http://www.cisco.com/warp/public/cc/pd/rt/2600/prodlit/a2636_ds.htm

So download any of above image or later with PLUS featureset..to fix the problem.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco