cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1347
Views
0
Helpful
1
Replies

Cisco 2950 igmp-snooping multicast support

r.fang
Level 1
Level 1

I have a cisco 2950 switch is receiving multicast traffic from Juniper router, there are two multicast mpeg-2 receivers connect to 2950 switch, the first receiver joins multicast group 239.0.0.3 and the second receiver joins multicast group 239.0.0.5. igmp-snooping was also turn on in the switch, I plug my PC with sniffer software installed( without multicast software) into switch, the packet trace still shows that the port PC attached to was receiving both multicast groups traffic( my PC should not see any Multicast traffic). but result of show mac-address-table multicast shows the right Multicast group and associated ports.

ASCNYBW01#show mac-address-table multicast vlan 2

Vlan Mac Address Type Ports

---- ----------- ---- -----

2 0100.5e00.0001 IGMP Fa0/17, Fa0/18

2 0100.5e00.0003 IGMP Fa0/17, Fa0/18

2 0100.5e00.0005 IGMP Fa0/17, Fa0/19

2 0100.5e78.0505 IGMP Fa0/17

so It looks like igmp snooping feature is not working on this switch as it suppose to.

The IOS on this 2950 switch is lastest code 12.1.12c. any idea???

Thanks

1 Reply 1

s.jankowski
Level 4
Level 4

I have not seen this problem before, here is a link with more information on setting up IGMP Snooping on the 2950. Hope that helps:

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat2950/12112cea/2950scg/swigmp.htm

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco