03-28-2006 04:42 AM - edited 03-03-2019 02:31 AM
i have a cisco 2950 switch.in the network which i want to create out of 24 ports i want two ports should be isolated from all other ports. and there should be only two ports among the remaining which can access those two ports and and also communicate with rest.
03-28-2006 04:51 AM
Hi Kalyan,
What u mean by accessing the ports???? If it just passing the traffic means you better configure those two ports in a single vlan each. and other ports in a different vlan.
But if u want to have two ports which needs to pass all traffic, better be in trunk mode allowing all the three vlans.
You can pass the three vlans thro. this two ports but if you want commuicate between vlans, you should have either L3 device or router to do the intervlan traffic.
Rate if it helps
Rgs,
03-28-2006 04:56 AM
Hi,
What you are asking for is VLANS to be conigured on 2950 switch which u cant , you need to have a layer 3 switch like 3550 switch so that these VLAN talk to each other or particular VLAN A talk to particular VLAN B
regards
EF
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide