Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

cisco 2950

i have a cisco 2950 switch.in the network which i want to create out of 24 ports i want two ports should be isolated from all other ports. and there should be only two ports among the remaining which can access those two ports and and also communicate with rest.

2 REPLIES
Silver

Re: cisco 2950

Hi Kalyan,

What u mean by accessing the ports???? If it just passing the traffic means you better configure those two ports in a single vlan each. and other ports in a different vlan.

But if u want to have two ports which needs to pass all traffic, better be in trunk mode allowing all the three vlans.

You can pass the three vlans thro. this two ports but if you want commuicate between vlans, you should have either L3 device or router to do the intervlan traffic.

Rate if it helps

Rgs,

New Member

Re: cisco 2950

Hi,

What you are asking for is VLANS to be conigured on 2950 switch which u cant , you need to have a layer 3 switch like 3550 switch so that these VLAN talk to each other or particular VLAN A talk to particular VLAN B

regards

EF

91
Views
0
Helpful
2
Replies
CreatePlease to create content