Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Cisco 3100 series catalyst router/switch

I am able to get into the configuration screen. However when trying to scroll down to the IP Configuration field, I get (MENU IS BUSY!) . Will peforming a reset from the Main Menu clear this up so I can get in to re-ip the switch??

2 REPLIES
Silver

Re: Cisco 3100 series catalyst router/switch

Make sure that you have followed the guidelines that has to be taken care while working within the console menus.

Under the reset function,there is a function called "Clear Nonvolatile RAM ".This will actually allow you to delete all user-configured parameters such as baud rate, IP address information, EtherChannel, VLAN, Spanning Tree, and then resets the switch.So ,you can give the Ip address again to the switch using this menu. But beware : Follow the instructions before clearing the NVRAM.

See the document for more details.

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat3ks/3000/ahcncnsl.htm#xtocid1258054

You can power cycle the Catalyst 3000 to re-run the diagnostics to see if that will clear the error.

New Member

Re: Cisco 3100 series catalyst router/switch

Thanks it worked.

503
Views
0
Helpful
2
Replies
CreatePlease to create content