In your scenario, you have a layer 3 division between your switches.
Switch A will know about all the VLAN subnets configured on it as well as the network link between the switches.
Switch B on the other hand will know about the subnets configured on it plus the link subnet. For reachability between all the subnets you need to run either a dynamic routing protocol (EIGRP,OSPF) or statically point routes for the subnets pointing to the correct layer3
Looks like your connecting links between the switches is in 2 different address ranges and that is what it is complaining about ,on one end you have 192.168.0.2 /24 address and the other is 192.168.1.0/24 address , can't do this , change one end or the other so that they are both in the same subnet range.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.