we have a 2948G going out. It was a good unit. We use IRB on that thing with BVI interfaces, etc. The problem I am having is that I can't configure a sub-interface, such as gigabitethernet0/1.1 to be on a bridge-group. The error message tells me that the LAN subinterface requires that the interface be already configured for 802.1Q encap. I have issued a "no switchport" on the main interface to get it, and the sub-interface, into routing mode. My problem here is that there is no "encap dot1q 3 native" sub-interface commands for the bridge-groups like there was on the the 2948G.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.