Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Cisco 3560 rate-limit for send & receive

hi

I

need to rate limit the traffic on each port I've also tried policing but when its applied to the specific interface using "service-policy output xxxx", i get the error "Warning: Assigning a policy map to the output side of an interface not supported" I've tried looking for solutions . could you pls help me !!!!!!!!!

1 REPLY
Hall of Fame Super Silver

Re: Cisco 3560 rate-limit for send & receive

You actually want to apply the servicy-policy input as the you are limiting traffic from PC to the network. Take a look at the QoS SRND doc:

http://www.cisco.com/application/pdf/en/us/guest/netsol/ns432/c649/ccmigration_09186a008049b062.pdf

Chris

123
Views
0
Helpful
1
Replies
CreatePlease to create content