Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

cisco 3600 router for dial-in

hello,

we have a CISCO 3600 router (FE-PRI 1FE-2CE1-B/U) for dial-in to our collegues who would like to work from home.

i ordered ISDN PRI for this purpose. the router is configured by a collegue of mine remotely.

so my question is: how should the ISDN PRI connected to the router?

now there is a DB-15 at the end of the cable like this:

pin signal

9 tx tip

2 tx ring

8 rx tip

15 rx ring

and it's directly connected to the router on ctrlr1.

when i call the number it's busy or even out of service. the line was measured, tested so it works. the problem could be with the connection, i think.

could anybody tell me please how should the router be connected to the ISDN PRI?

many thanks. Csilla

1 REPLY

Re: cisco 3600 router for dial-in

Often times complex troubleshooting issues are best addressed in an interactive trouble-shooting session with one of our trained technical assistance engineers. While other forum users may be able to help, it’s often difficult to do so for this type of issue.

To utilize the resources at our Technical Assistance Center, please visit http://www.cisco.com/tac and to open a case with one of our TAC engineers, visit http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

223
Views
0
Helpful
1
Replies
CreatePlease to create content