hello,
we have a CISCO 3600 router (FE-PRI 1FE-2CE1-B/U) for dial-in to our collegues who would like to work from home.
i ordered ISDN PRI for this purpose. the router is configured by a collegue of mine remotely.
so my question is: how should the ISDN PRI connected to the router?
now there is a DB-15 at the end of the cable like this:
pin signal
9 tx tip
2 tx ring
8 rx tip
15 rx ring
and it's directly connected to the router on ctrlr1.
when i call the number it's busy or even out of service. the line was measured, tested so it works. the problem could be with the connection, i think.
could anybody tell me please how should the router be connected to the ISDN PRI?
many thanks. Csilla