I have been asked to configure two Cisco 3620s to talk to each other over a megastream line. As I have mainly worked with Gigabit Ethernet, I thought a good starting point would be Config Maker. I added the two routers, both with the same PRI Network modules but I was unable to add an ISDN line between them. Config Maker stated that one must be PRI and the other BRI. Am I being asked to do the impossible?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...