Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cisco 3640 and NM-8AM module config

I have a 3640 with an NM-8AM. I have four analog lines that I am going to plug directly into this module for my dial-in users. Can I assign a block of IP addresses from my E0 interface for the dial-in pool, or does this have to be a separate subnet? Do you have any sample configs for the NM-8AM module?

  • Other Network Infrastructure Subjects
1 REPLY
Anonymous
N/A

Re: Cisco 3640 and NM-8AM module config

Yes it is possible.

first you will have to check which lines on the router to bind .

to understand the line numbering, you can chack the following URL.

http://www.cisco.com/univercd/cc/td/doc/product/access/acs_mod/cis2600/net_mod2/coanalog.htm#xtocid99233

Second, you can configure the 'interface group-async x' where you will be with the following command able to bind several lines :

group-range x y

you can check commands and samples on this following URL link :

http://www.cisco.com/univercd/cc/td/doc/product/access/acs_mod/cis2600/software/config.htm#xtocid417125

You can defined on this interface the following command to save Ip address' :

IP unnumbered e0

92
Views
0
Helpful
1
Replies
This widget could not be displayed.