Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cisco 3640 and VWIC 1MFT-E1 PRI

Hi ,

i have a Cisco 3640 with the following interface VWIC 1MFT-E1 . and 12 DM I want configure this router as a Accessserver . My problem is , that i can't configure at the controller e1 the pri-group 1-31 . Is it possible that the VWIC 1MFT-E1 doesn't support PRI ?

ANy hints ?

Thanks

2 REPLIES
Cisco Employee

Re: Cisco 3640 and VWIC 1MFT-E1 PRI

It supports ISDN PRI signaling BUT ISDN data connection is not supported. The card can not terminate ISDN 64K or 56K data connection: It only supports voice-call termination when using ISDN PRI signaling. Pl. visit following url for more on that card

http://www.cisco.com/warp/public/788/products/vwicmf_e1.html

New Member

Re: Cisco 3640 and VWIC 1MFT-E1 PRI

Hi ,

thank you for the information. In this case , i have to change the modul to a NM-1CE1B .I think this is the solution for the problem . somtetimes it is better , to read the product info .

regards

Hermann

263
Views
5
Helpful
2
Replies