We have cisco3640 router which is loaded with IPv6 flash image, suddenly it went off the network and when we switch OFF/ON its console come up with "rmon1>" prompt, then again we loaded the Ipv6 image "c3640-is-mz.122-2.T.bin" (previous image was also same) and gave "reload" command, its rebooted and start giving some junk massages and start behaving erratic. We did the configuration in same condition and after saving the configuration to NVRAM we OFF/ON once again and now it is not giving any console massage and some ASCII character appears at console screen. Please can some one guide us what could be wrong in our router.
It is likely that the boot statement in your configuration still points to the old IOS. The following document outlines ROMmon Recovery for the Cisco 3600 Series Router and will walk you through solving this issue:
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...