We're trying to upgrade the IOS on our Cisco 3725. We installed a new internal flash (requires 128Mb instead of 32Mb), copied the new ios to the internal flash, with the vtlan.dat and the running-config.
went to the config t prompt and typed
"boot system slot0:c3725-adventerprisek9-mz124-6-t2.bin" then typed reload, it said config has changed do you want to save said yes, then it said confirm reload. when it re loaded it said error can not open "slot0:c3725-adventerprisek9-mz124-6-t2.bin" error -13.
Is the router up and running now but running a different code than what you wnat? If so you can dir slot0: to confirm the file name. what you typed - "slot0:c3725-adventerprisek9-mz124-6-t2.bin" does not look right. the file name would generally look like "c3725-adventerprisek9-mz.124-6-t2.bin" note the "period" between the "mz" and the "124". the point is making sure the file name you type is exactly the same as what appears in the slot0:.
If it's internal flash why is it slot0:? should it not be flash:? Can you post dir flash: and dir slot0:? In addition, wherever you see an image either flash or slot0, can you manually boot with "boot slot0: orflash:" whatever it maybe? It does look like there is a typo somewhere.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...