I have the above mentioned set up in my lab. I need to connect to a T1. Is there a T1 DSU/CSU module available for this series router, or is there another type of adapter or module that I would have to use to make it accessible?
I have had good experiences with Adtran CSUs. might cost you around 800-900 bucks a piece. You can get used ones at ebay or refurbished equipment resellers. for even lesser than that....Hope that helps.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...