Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cisco 4000-M and short circuit

Hi, i just received another 4000-M that I was going to use as a simulated backbone router for a home lab. At present it does not have any modules. Two of the slots are open (they do not have any cover to close them).

Now when I start the router it shorts the circuit. This is when I just connect the cable to the wall plug. I haven't even started the router yet. I think it may be a bad power supply. Appreciate any suggestions on what to do or if I am wrong about the power supply. The power supply is the regular AC 120-240. Thanks

1 REPLY
Bronze

Re: Cisco 4000-M and short circuit

There is a short circuit in your power supply. Replace the power supply with a good one and try again.

97
Views
0
Helpful
1
Replies