plz fine the post test script...
003-B-Ground> (enable) 0:00.523556: Please set IPAddr variable
0:00.524147: Please set Netmask variable
0:00.524511: Please set Broadcast variable
0:00.525113: Please set TftpServer variable to do tftp downloads
0:00.525658: Network is not configured
WS-X4012 bootrom version 5.4(1), built on 2000.02.17 18:28:09
H/W Revisions: Meteor: 4 Comet: 8 Board: 2
Supervisor MAC addresses: 00:02:16:d2:5a:00 through 00:02:16:d2:5d:ff (1024 addr
esses)
Installed memory: 64 MB
Testing LEDs.... done!
The system will autoboot in 5 seconds.
Type control-C to prevent autobooting.
rommon 1 >
The system will now begin autobooting.
Autobooting image: "bootflash:cat4000.5-4-2.bin"
CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC
CCCCCCCCCCCCCCCCCCCCCCCCCCC#############################
Starting Off-line Diagnostics
Mapping in TempFs
Board type is WS-X4012
DiagBootMode value is "post"
Telling ApkPageMan that we have 12288 pages of memory
Loading diagnostics...
Power-on-self-test for Module 1: WS-X4012
Status: (. = Pass, F = Fail)
processor: . cpu sdram: . rtc: F
eprom: . nvram: . flash: .
temperature sensor: . enet console port: . switch port 0: .
switch port 1: . switch port 2: . switch port 3: .
switch port 4: . switch port 5: . switch port 6: .
switch port 7: . switch port 8: . switch port 9: .
switch port 10: . switch port 11: . switch registers: .
switch sram: .
Module 1 Failed
Power-on-self-test for Module 2: not present
Port status: (. = Pass, F = Fail)
Module 2 Ignored
Power-on-self-test for Module 3: not present
Port status: (. = Pass, F = Fail)
Module 3 Ignored
Exiting Off-line Diagnostics
Failed Module Bringup Process
Use 'show test 1' to see results of tests.
Cisco Systems, Inc. Console
