Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

cisco 4003 series switch

Hi...All.

In cisco 4003 series switch i m getting error in post test its says , rtc failed, after that supervisorengineer wxx4012 LED status is Red.can any one tell me wt that means and hw to solve that problem.

3 REPLIES

Re: cisco 4003 series switch

Hi Manoj

AFAIK it indicates some problem with the real time clock can you post the full error message captured from your console ?

regds

New Member

Re: cisco 4003 series switch

plz fine the post test script...

003-B-Ground> (enable) 0:00.523556: Please set IPAddr variable

0:00.524147: Please set Netmask variable

0:00.524511: Please set Broadcast variable

0:00.525113: Please set TftpServer variable to do tftp downloads

0:00.525658: Network is not configured

WS-X4012 bootrom version 5.4(1), built on 2000.02.17 18:28:09

H/W Revisions: Meteor: 4 Comet: 8 Board: 2

Supervisor MAC addresses: 00:02:16:d2:5a:00 through 00:02:16:d2:5d:ff (1024 addr

esses)

Installed memory: 64 MB

Testing LEDs.... done!

The system will autoboot in 5 seconds.

Type control-C to prevent autobooting.

rommon 1 >

The system will now begin autobooting.

Autobooting image: "bootflash:cat4000.5-4-2.bin"

CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC

CCCCCCCCCCCCCCCCCCCCCCCCCCC#############################

Starting Off-line Diagnostics

Mapping in TempFs

Board type is WS-X4012

DiagBootMode value is "post"

Telling ApkPageMan that we have 12288 pages of memory

Loading diagnostics...

Power-on-self-test for Module 1: WS-X4012

Status: (. = Pass, F = Fail)

processor: . cpu sdram: . rtc: F

eprom: . nvram: . flash: .

temperature sensor: . enet console port: . switch port 0: .

switch port 1: . switch port 2: . switch port 3: .

switch port 4: . switch port 5: . switch port 6: .

switch port 7: . switch port 8: . switch port 9: .

switch port 10: . switch port 11: . switch registers: .

switch sram: .

Module 1 Failed

Power-on-self-test for Module 2: not present

Port status: (. = Pass, F = Fail)

Module 2 Ignored

Power-on-self-test for Module 3: not present

Port status: (. = Pass, F = Fail)

Module 3 Ignored

Exiting Off-line Diagnostics

Failed Module Bringup Process

Use 'show test 1' to see results of tests.

Cisco Systems, Inc. Console

Purple

Re: cisco 4003 series switch

Time to RMA the supervisor.

220
Views
0
Helpful
3
Replies