Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
You may experience some slow load times, errors, and slight inconsistencies. We ask for your patience as we finalize the launch. Thank you.

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cisco 4507 IOS Installation for Supervisor Engine IV

Hi,

Recently we purchased Cisco IOS Enhanced L3 SW (OSPF, IGRP) for

Supervisor IV engine.

CD itself is nothing but a single .bin file (cat4000-is-mz.121-12c.EW1.bin)

I just wanted to make sure before I make any progress.

I have Cisco 4507R chasis with two Sup IVs and one X48 10/100/1000 module.

My qeustions are;

1. How do I install this IOS? copy tftp: flash:filename.bin?

2. Do I need to install this to each Sup IV engine?

3. Anything else need to be done after installing IOS?

Thank you very much for your help in advance.

  • Other Network Infrastructure Subjects
2 REPLIES
Cisco Employee

Re: Cisco 4507 IOS Installation for Supervisor Engine IV

You can find upgrade procedures at

http://www.cisco.com/warp/customer/473/179.html

You'll need a TFTP server and you can get one at

http://tftpd32.jounin.net/

Yes. You'll need to install this on both Supervisors.

New Member

Re: Cisco 4507 IOS Installation for Supervisor Engine IV

Thanks!

Actually this is brand new hardware and we're not upgrading IOS.

Does each supervisor Engine IV has its basic IOS installed?

Otherwise how could I enter priviledge mode to each sup IV engine?

Thanks.

132
Views
0
Helpful
2
Replies